A, in partes Lubricating oleum:
I) In cochlea et compressio cubiculum et inter Yin et Yang screw ad formare dynamic sigillum, reducere in refrigerare in compressionem processum a summo pressura parte ad humilis pressura processum a summo pressura parte ad humilis pressura ex alto pressura latus ad low pressura parte de pressura.
II) refrigerationem refrigerandum esse compressi, oleum est sprayed in compressor, absorbuit calor generatae per refrigerare Gas in compressionem processus, reducendo exhauriunt temperatus.
III) in afferentem et stupra inter formationem oleum film ad suscipere rotor et ludere a partes in lubricatae.
IV) Transfero differentialis vis, eiciam facultatem temperatio ratio, per actiones in compressor scriptor unloading et addendo solenoidal valvae, adjusting in situ facultate temperatio imperium.
V) Redigo operating sonitus
Description:
Compressor internum lubricant est clavem esse normalis operationem in compressor, generalis lubricant problems sunt:
I) Foreign materia mixta, unde in lubricating oleum pollutio, claudebant oleum filter.
II) summus temperatus effectus causat lubricant ad deteriorem et perdere lubrication munus.
III) ratio aqua pollutio, acidification, exesa motricium.
Secundo, in compressor refrigeration oleum temptationis et replacement:
Nam ratio manufacturer, in compressor refrigeration oleum temptationis et replacement exolvuntur est ad processus imperium eius productio processus. Si systematis scriptor evaporator et condenser et system et system eleemosum munditiam potestate relative bonum, tunc relative minus contaminantium in compressor, deprehendatur et sustentacionem cycle potest esse secundum quid.
Main Cras Indicatores:
I) PH Value Index: et acidification de lubricating oleum et directe afficit ad vitam compressor motricium, ita acetosum de lubricating oleum debet esse sedatus regulariter videre, si idoneus. General Lubricant acetosum infra ph6 requiritur ad reponere. Si acetosum non sedatus, filter siccior systema debet reponi regulariter ut ratio siccitatem in normalis conditio.
II), pollutio Index: si pollutants in 100ml of refrigeration oleum excedunt 5mg, commendatur reponere refrigerationem oleum.
III) aqua contentus: si excedit 100ppm, necesse est reponere refrigerationem oleum.
Postea cycle:
Plerumque omnis 10,000 horas operandi et reprehendo vel reponere ad lubricant, et post primam operationem, MMD horas commendatur reponere ad Lubricant et emundare oleum filter. Quia residuum de consilio erit exaggeratus in compressor post officialis operationem. Ideo et Lubricating oleum debet mutari semel in MMD horas (seu III mensibus), et tunc regulariter secundum system mundatless, si ratio munditia est bonum, quod possit mutari semel omne (X) (vel annuatim mutari (X) (vel annuatim.
Compressor fluxum temperatus, si diu-term sustentacionem in altum temperatus statum, tunc in Lubricant depravatione progressus celeriter, oportet esse regulariter (omnis II mensibus) reprehendo in chemical characteres in Lubricant, defecit ad reponi. Si non reprehendo regulariter potes sequi sequenti suggestione mensa.
Tres, REFRIGERATIO oleum postea operatio modum:
I) Refrigeration oleum replacement sine internum Purgato:
The compressor does pumping action to recover the system refrigerant to the condenser side (note that the minimum suction pressure of pumping action is not less than 0.5Kg/cm2G), remove the refrigerant from the compressor, retain some internal pressure as the power source, and discharge the refrigerant oil from the oil discharge angle valve of the compressor.
II) mutare Refrigerant oleum et mundatis in medio:
Drain the oil action as described above, after the refrigerant oil is removed and the pressure inside and outside the compressor is balanced, use the hexagonal wrench to loosen the flange bolts, remove the oil filter connector and clear the hole flange (or oil level switch flange), remove the pollutants in the compressor oil tank, and check whether the oil filter hole mesh is broken, and blow out the sludge and pollutants on it, or replace the oil Filter cum novo note quod repositoque novum filter interface nut debet esse screwed arcte et obsignatorum bene ne internum lacus; In liner intra oleum filter iuncturam debet reponi cum novum unum ne internum lacus; Alia Lince Liner est etiam suadetur ut renovata.
IV. Praecipua:
I. Diversis faces REFRIGERATIO oleum debet esse mixta, praesertim mineralis oleum et syntheticam est oleum non misceri.
II. Si repositoque diversis gradibus refrigerationis oleum, attendere ad originale refrigerationem oleum reliqua in systema ut excluduntur.
III. Aliqui oleil sunt hygroscopic, ut non exponant oleum ad aere diu. Shorten in nuditate tempore quantum fieri potest et decedere quantum fieri potest per installation.
4. If the system has a compressor motor burn failure, pay special attention to remove the residual acid from the system when replacing the new machine, and check the acidity of the refrigeration oil after seventy-two hours of commissioning operation, it is recommended to replace the refrigeration oil and filter drier to reduce the possibility of acid corrosion. Postmodum, test aut reponere refrigerare oleum iterum post de uno mense operandi.
V. Si ratio habuit accidente aqua ingressu, stipendium specialem operam ad removendum aqua mundius, et praeter ad repositoque in refrigerationem oleum et reponere novum oleum et filter siccior in tempore.
Post tempus: May-29-2023
